Active and preferred

IF-BOARD.DP-GEN2

board
ea.
in stock

Content could not be loaded

Unfortunately, we were unable to load the content for this section. You may want to refresh the page or try again later.

IF-BOARD.DP-GEN2
IF-BOARD.DP-GEN2
ea.

Product details

  • Board Type
    Evaluation Board
  • Family
    LED Driver
  • Target Application
    LED Lighting, Lighting
Recommended
OPN
IFBOARDDPGEN2TOBO1
Product Status active and preferred
Infineon Package --
Package Name N/A
Packing Size 1
Packing Type CONTAINER
Moisture Level N/A
Moisture Packing NON DRY
Lead-free No
Halogen Free No
RoHS Compliant No
Infineon stock last updated:
 ea. in stock

Product Status
Active
Infineon Package --
Package Name -
Packing Size 1
Packing Type CONTAINER
Moisture Level -
Moisture Packing NON DRY
Lead Free
Halogen Free
RoHS Compliant
ea.
in stock
This is the galvanic isolated and CE certified .dp InterfaceGen2, which is used to set parameters and protection behavior for digital power products. It can be used to either test parameter temporarily or to burn them permanently. The .dp device will be connected via USB to a computer and is controlled using the .dp Vision Software.

Features

  • .dp Interface Gen2 for parameterization of .dp products via .dp vision
  • Safe and galvanic isolation from DP2x board to low voltage side (USB)
  • Startup sequence and VCC supply voltage for DP2x is generated on the .dp Interface Board Gen2
  • Short circuit detection on VCC
  • Status LEDs for power, sync and PC connection
  • CE certified
  • Easily adaptable to specific application boards via standard 8-pin (2x4 pins) connector @Interface board
  • Firmware of the .dp Interface Board Gen2 can be updated via USB

Applications

Bill of Material

Documents

Documents

Design resources

Partner solutions