CDM10V-3 is a fully integrated 0-10V dimming interface IC and comes in a 6-pin SOT package to cover space requirements on small PCBs. The device is targeted for various dimming applications in lighting. The IC can be used to transmit analog voltage based signals from a 0-10V dimmer or potentiometer to the dimming or PWM input of a lighting controller IC in the form of a current based PWM signal to drive an external opto-coupler.
CDM10V-3 replaces many components in a traditional solution and reduces BOM and PCB space significantly. It supports active and passive dimming - one solution for various applications!
- PWM output frequency: 1kHz
- Dimmer/resistor bias current: 200µA
- Dim-to-off: disabled
- Min-duty-cycle: 1%
- Wide input V cc range: 11-25V
- Transparent PWM mode
- Replaces many external components with single chip reducing BOM and PCB space
- Minimum variation from device to device
- LED drivers needing 0-10V dimming circuits
- Office lighting
- Signage applications
Find an answer to your question
Technical Assistance Center (TAC)
Infineon welcomes your comments and questions.
If you have any questions concerning our products, please fill out the following form. Your inquiry will be sent to the appropriate specialist who will be in touch with you as soon as possible.
You will receive a confirmation E-mail to validate your address in our system. Any attached file to the reply which will help to support your inquiry is highly appreciated.