TLE9862QXA40

Summary of Features

• On-chip OSC and PLL for clock generation
  • PLL loss-of-lock detection

• MOSFET driver including charge pump
• 10 general-purpose I/O Ports (GPIO)
• 5 analog inputs, 10-bit A/D Converter (ADC1)
• 16-bit timers - GPT12, Timer2, Timer21, and Timer3
• Capture/compare unit for PWM signal generation (CCU6)
• 2 full-duplex serial interfaces (UART) with LIN support (for UART1 only)
• 2 synchronous serial channels (SSC)
• On-chip debug support via 2-wire SWD
• 1 LIN 2.2 transceiver
• 1 high-voltage monitoring input
• Single power supply from 5.5 V to 27 V
• Extended power supply voltage range from 3 V to 28 V
• Low-dropout voltage regulators (LDO)
• High-speed operational amplifier for motor current sensing via shunt
• 5 V voltage supply for external loads (e.g., Hall sensor)
• Core logic supply at 1.5 V
• Programmable window watchdog (WDT1) with independent on-chip clock source
• Power-saving modes
  • MCU slow-down mode
  • Sleep mode   
  • Stop mode
  • Cyclic wake-up sleep mode

• Power-on and undervoltage/brownout reset generator
• Overtemperature protection
• Short-circuit protection
• Loss of clock detection with fail-safe mode entry for low system power consumption
• Temperature range Tj = -40°C to +150°C

Features of the Microcontroller

• 32 bit Arm® Cortex®-M3 Core, up to 40 MHz clock frequency
• On-chip memory
  • 256 KB flash including
  • 4 KB EEPROM (emulated in flash)
  • 512 byte 100-time programmable memory (100TP)
  • 8 KB RAM
  • Boot ROM for startup firmware and flash routines
• Thumb®-2 Instruction Set and hardware divide and multiplication unit
• 16-bit timers - GPT12, Timer2, Timer21, and Timer3
• Capture/compare unit for PWM signal generation (CCU6)

Benefits

• Complete System-on-Chip for DC motor control
• Minimum number of external components reduce BOM cost
• PG-VQFN package with 7 x 7 mm footprint enable PCB space saving