Increase energy efficiency, decrease power losses
For top performance in industrial settings, a linear actuator must be robust and resistant to environmental stress. Qualities that can be achieved with the right semiconductor solutions.
In Infineon’s wide range of high-quality products, you’ll find what you’re looking for. In terms of capabilities, time to market, and budget. From robust protected switches – such as the PROFET™ and HITFET™ families – to proven reference designs specifically for industrial linear actuators, like our relay unit for PLC. Also, we offer several solutions to drive actuators in industrial environments. Including PWM-enabled drivers or CCRD, both of which reduce local power losses and increase the energy efficiency of your overall system.
Linear actuator system diagram
This application board enables you to test the IFX81481ELV high efficiency synchronous step-down DC/DC controller.
It is equipped with IFX81481ELV and is pre-adjusted to an output voltage of 5.6V. The application board enables the user to test the performance with two different configurations of the current limit. The board is fully equipped with external components, including two high performance MOSFET switches.
This application board enables you to test the performance of the IFX90121 basic buck converter.
It is equipped with a IFX90121EL V50 with a fixed 5V output voltage. The application board for the IFX90121 enables the user to test the performance of the low Iq, 5V buck converter. The board is fully equipped with external components.
This application board enables you to test the performance of the IFX91041 basic buck converter. It is equipped with a IFX91041EJV for variable output voltages (preadjusted to 4.8V). The board offers several options to modify the schematic and also the possibility to drive LEDs.
Multi-purpose buck controller for external PMOS switch, 5V or adjustable output voltage, maximum of 2.3A output current, low quiescent current.
The HITFET™ Demoboards are a small PCB where a engineering sample is already mounted with a 6 cm² copper cooling area. All device pins can be directly accessed for customer measurements
XMC1000 Motor Control Application Kit
Implements TLV5012B angle sensor enabling accurate rotor position detection. MCU board with XMC1300 and detachable SEGGER J-Link debug interface - Motor Board: 12 – 24V, up to 3A, On board 3-phase motor (24V, 15W) with hall sensors, Optional encoder interface.
Smallest, fully featured evaluation kits - The 3D Magnetic Sensor 2GO is a budget-priced evaluation board equipped with a magnetic sensor for three dimensional measurement combined with an ARM® Cortex™-M0 CPU. The 3D Magnetic Sensor 2GO has a complete set of on-board devices, including an on-board debugger. Build your own application and gadget with the 3D Magnetic Sensor 2GO.
Find an answer to your question
Technical Assistance Center (TAC)
Infineon welcomes your comments and questions.
If you have any questions concerning our products, please fill out the following form. Your inquiry will be sent to the appropriate specialist who will be in touch with you as soon as possible.
You will receive a confirmation E-mail to validate your address in our system. Any attached file to the reply which will help to support your inquiry is highly appreciated.